.. include:: ./../../../macros.txt .. include:: ./../../../units.txt .. _INTERFACE_LTC_6820_V1_0_3: Interface LTC-6820 V1.0.3 ========================= .. |local_interface_version| replace:: ``1.0.3`` -------- Overview -------- .. important:: The following description only applies for the |ltc6820|\ -based |bms-interface| hardware version |local_interface_version|. .. hint:: All connector pinouts described below follow the :ref:`CONVENTION_FOR_CONNECTOR_PIN_NUMBERING`. The |bms-interface| is used to enable communication between the |bms-master| and the |bms-slaves|. A 3D rendering of the |bms-interface| is shown in :numref:`Fig. %s <interface-ltc6820_v1.0.3_rendering>`. The |bms-interface| is intended to be used together with a |bms-master|. .. _interface-ltc6820_v1.0.3_rendering: .. figure:: ./ltc-ltc6820-v1.0.3/ltc-ltc6820-v1.0.3_rendering.png :width: 100 % 3D rendering of the |bms-interface| ^^^^^^^^^^^^^ Block Diagram ^^^^^^^^^^^^^ |tbc| ^^^^^^^^^^^^^^^^^^^^^^^^^^ Schematic and Board Layout ^^^^^^^^^^^^^^^^^^^^^^^^^^ More information about the board schematic and layout files can be found in section :ref:`DESIGN_RESOURCES`. --------- Functions --------- ^^^^^^^^^^^^^^^^^^^^ isoSPI communication ^^^^^^^^^^^^^^^^^^^^ The |bms-interface| offers up to four isolated isoSPI communication channels using the |ltc6820| transceiver chip from |adi|. The |ltc6820| transceivers are controlled by the SPI signals from the |bms-master|. The isoSPI signals are available on the connectors J101, J102, J103 and J104. The pinout is described in :numref:`Table %s <interface-ltc6820_v1.0.3_isoSPI_connectors>`. .. csv-table:: isoSPI Daisy Chain Output Connectors :name: interface-ltc6820_v1.0.3_isoSPI_connectors :header-rows: 1 :delim: ; :file: ./ltc-ltc6820-v1.0.3/ltc-ltc6820-v1.0.3_isospi_connectors.csv -------------- Specifications -------------- ^^^^^^^^^^^^^^^^^^^^^ Mechanical Dimensions ^^^^^^^^^^^^^^^^^^^^^ The size of the PCB is 70x120mm. ^^^^^^^^^^^^^^^^ isoSPI Isolation ^^^^^^^^^^^^^^^^ |tbc|