5.2.1.2. NXP MC33775A-based 14-Cell Slave v1.0.0
Note
The changelog for this release is found at v1.0.0.
5.2.1.2.1. Overview
Important
The following description only applies for the NXP MC33775A-based 14
cell BMS-Slave Board hardware version 1.0.0.
Hint
All connector pinouts described below follow the Convention for Molex Micro-Fit 3.0 Connector Pin Numbering.
5.2.1.2.2. Specifications
5.2.1.2.2.1. Electrical Ratings
This section of the documentation is not yet complete.
5.2.1.2.2.2. Mechanical Dimensions
Description |
Value |
Unit |
|---|---|---|
Width |
100 |
mm |
Length |
160 |
mm |
Height |
15 |
mm |
Weight |
88 |
g |
5.2.1.2.2.3. Block Diagram
This section of the documentation is not yet complete.
5.2.1.2.2.4. Schematic and Board Layout
More information about the board schematic and layout files can be found in section Design Resources.
5.2.1.2.3. Functions
5.2.1.2.3.1. Cell Voltage Measurement
This section of the documentation is not yet complete.
5.2.1.2.3.2. Passive Cell Balancing
This section of the documentation is not yet complete.
5.2.1.2.3.3. Global Cell Balancing Feedback
This section of the documentation is not yet complete.
5.2.1.2.3.4. Temperature Sensor Measurement
This section of the documentation is not yet complete.
5.2.1.2.3.5. On-board EEPROM
This section of the documentation is not yet complete.
5.2.1.2.3.6. isoSPI Daisy Chain Connection
The data transmission between the slaves and between the slaves and the basic board takes place using the TPL interface.
This section of the documentation is not yet complete.
